OKI C610 Fuser Unit Reset Chip

Zinetic fuser reset chips will allow to reset your fuser unit for another cycle and save lots of money. If your printer has told you to replace the fuser unit when its set page count has been reached, our reset chips will reset your fuser page life, allowing you to carry on using your fuser for another cycle. So, if you have a message saying ‘Fuser Unit Near Life, Change Fuser Unit, or Replace Fuser’ warning that appears on your printer, but the fuser is still working, you can save lots of money by installing our reset chip. All of our reset chips come with specific model instructions so the reset cable can be installed easily by the average end user.

How To Install A Fuser Reset Chip

Before installing the reset chip, we advise that that you switch off your printer and allow the printer to stand off for 20-25 minutes to allow your fuser unit to cool down correctly. After allowing the fuser unit to cool down, remove the fuser from your printer and install the reset chip as shown in the video below.

Other Useful Information:

You can reset a working fuser unit with our stick on reset chip. The chip will reset and remove the following 3 warning messages: Fuser Unit Near Life, Change Fuser Unit, Replace Fuser unit and this inturn will allow you to use the fuser for another full cycle. If you have any error messages or issues with your fuser unit other than the messages shown please contact us for advice before buying.